Sebring LXI Convertible V6-2.7L VIN R (2002)
Transmission Speed Sensor: Service and Repair
REMOVAL
1. Raise vehicle on hoist.
2. Disconnect the speed sensor connector (Fig. 128) .
CAUTION: Clean area around speed sensor before removing to prevent dirt from entering the transaxle during speed sensor removal.
3. Remove speed sensor retaining bolt (Fig. 128) .
4. Remove speed sensor from transaxle.
CAUTION: Carefully remove vehicle speed sensor so that sensor drive gear does not fall into transaxle. Should sensor drive gear fall into the
transaxle during sensor removal, drive gear must be reattached to sensor.
5. Remove speed sensor drive gear from speed sensor.
INSTALLATION
1. Install pinion gear to speed sensor (Fig. 128) .
2. Using a NEW O-ring, install the speed sensor to the transaxle (Fig. 128) .
3. Install the bolt and torque to 7 Nm (60 in. lbs.).
4. Connect speed sensor connector (Fig. 128) .
5. Lower vehicle and road test to verify proper speedometer operation.
