Sebring LXI Sedan V6-2.7L VIN R (2002)
Coolant: Service and Repair
Coolant Outlet Connector
COOLANT OUTLET CONNECTOR
REMOVAL
WARNING: DO NOT REMOVE PRESSURE CAP WITH THE SYSTEM HOT AND UNDER PRESSURE BECAUSE SERIOUS BURNS
FROM COOLANT CAN OCCUR.
1. Drain cooling system.
2. Remove upper intake manifold.
3. Disconnect Engine Coolant Temperature (ECT) sensor connector.
Fig. 11 Hose Clamp Pliers 8495
4. Disconnect hoses at coolant outlet connector. Use Special Tool 8495 Pliers to remove clamps.
Fig. 12 Coolant Outlet Connector - 2.7L
5. Remove bolts attaching coolant outlet connector.
6. Remove coolant outlet connector.
INSTALLATION
1. Clean sealing surfaces. Inspect gaskets for tears and cuts. Replace as necessary.
2. Install coolant outlet connector and tighten bolts to 12 Nm (105 in. lbs.).