Sebring LXI Sedan V6-2.7L VIN R (2002)
9. Install rear hub and bearing assembly on knuckle and install hub and bearing assembly retaining nut. Tighten retaining nut to a torque of 250 Nm
(185 ft. lbs.).
10. Install the brake drum on the hub/bearing assembly.
11. Install wheel and tire assembly on vehicle. Progressively tighten the wheel mounting nuts in crisscross sequence until all nuts are torqued to half
specification. Then repeat the tightening sequence to the full specified torque of 135 Nm (100 ft. lbs.).
12. Lower vehicle.
13. Check and reset rear wheel alignment to specifications if required.