Sebring Sedan L4-2.4L VIN J (2004)
Front Door Window Regulator: Service and Repair
WINDOW REGULATOR
REMOVAL
1. Remove door trim panel.
2. Remove glass from regulator roller channel. Secure glass in the up position in the door frame.
3. Disconnect power window motor wire connector.
4. Loosen screw attaching regulator scissor channel to door panel.
5. Remove screw and bolt heads from keyhole slots in door panel.
6. Loosen bolts attaching regulator to door panel.
Fig. 33
7. Remove regulator from door panel (Fig. 33).
8. Slide regulator rearward and rotate forward end of roller channel through access hole in door panel.
REMOVAL - JR-27 (Convertible) ONLY
1. Remove door trim panel and water shield.
2. Disconnect wire connector to power window motor.
3. Remove nuts attaching regulator lift channel to door glass.
4. Secure door glass in upward position.
5. Mark position of rear bolt of roller channel to inner door panel to aid in installation.
6. Remove bolt attaching rear of roller channel to door panel.
7. Loosen bolt attaching front of roller channel to door panel.