Sebring Sedan L4-2.4L VIN J (2004)
Brake Caliper: Service and Repair
Front Disc Brake Caliper
DISC BRAKE CALIPER FRONT
REMOVAL
1. Depress the brake pedal past its first inch of travel and hold it in this position using a brake pedal depressor (holding) tool. This is done to isolate
the master cylinder from the brake hydraulic system disallowing the brake fluid to completely drain out of the brake fluid reservoir.
2. Raise the vehicle. .
3. Remove front wheel and tire assembly.
4. Remove the anti-rattle spring from the outboard side of the caliper and adapter (Fig. 23).
5. Remove the banjo bolt connecting the brake hose to the brake caliper (Fig. 24). There are two washers (one on each side of the brake hose fitting)
that will come off with the banjo bolt. Discard these washers.
6. Remove the two caps in place over the caliper guide pin bolts (Fig. 24).