Sebring Sedan L4-2.4L VIN J (2004)
Parking Brake Cable: Service and Repair
CABLES PARKING BRAKE
REMOVAL
For servicing either the left or right rear parking brake cable, follow the procedure as listed below.
1. Remove center floor console.
2. Lower park brake lever handle.
3. Loosen adjusting nut (Fig. 73) on park brake cable output cable. This will take tension off park brake cables, allowing rear park brake cables to be
easily removed from tension equalizer.
4. Remove parking brake cable requiring service from the parking brake cable tension equalizer (Fig. 74).
5. Remove rear seat cushion from vehicle.
6. Remove scuff plates from right and left rear door sills. Scuff plates are attached to door sills using clips on bottom of scuff plates. Remove by
carefully prying scuff plate retaining clips out of door sills.
7. Fold rear carpeting forward to expose park brake cables.
