Sebring Sedan L4-2.4L VIN J (2004)
14. Remove parking brake cable from rear disc brake adapter or drum brake support plate. If access allows, place a 1/2 inch or 13 mm box wrench
over cable housing and compress locking tabs on cable retainer (Fig. 77). If access does not allow, a screwdriver may be used to press each tab in
individually while light pulling tension is applied to cable from rear. Once all tabs are compressed, pull cable out of adapter/plate.
15. Remove fasteners securing two cable routing clips to frame rail.
16. Remove parking brake cable and sealing grommet (Fig. 78) from floor pan of vehicle.
INSTALLATION
For servicing either the left or right parking brake cable, follow the procedure as listed below.
1. Install parking brake cable into floor pan of vehicle making sure sealing grommet is installed in floor pan as far as possible to insure a proper seal
(Fig. 78).
2. Install parking brake cable into rear disc brake adapter or drum support plate. Once installed in place, be sure locking tabs on cable housing
retainer are expanded.
NOTE: Parking brake cable routing and routing clips are different on right and left sides of vehicle. Be sure correct routing clips are installed on
correct side of vehicle.
3. Attach two parking brake cable routing clips on rear frame rail. Install and securely tighten routing clip attaching screws.