Sebring Sedan L4-2.4L VIN J (2004)
4.
Using a six inch wobble plus extension friction ball and shallow socket following the torque sequence (Fig. 1), loosen one bolt at a time to 0
torque and then torque that same head bolt to 60 Ft-lbs.
5.
Repeat step 4 for every head bolt one bolt at a time in sequence.
6.
Verify that each head bolt is at 60 Ft-lbs before performing next steps.
7.
After all head bolts have been verified to be torqued to 60 Ft-lbs follow the torque sequence and turn the head bolts an additional 90° (1/4 turn)
(Fig. 1).
8.
Following the appropriate procedures outlined in TechCONNECT install the cylinder head cover. Refer to 9 - Engine/Cylinder Head/Cylinder
Head Cover - Installation
9.
Install radiator cap.