Sebring Sedan L4-2.4L VIN J (2004)
Ignition Cable: Service and Repair
REMOVAL
Failure to route the cables properly could cause the radio to reproduce ignition noise, cross ignition of the spark plugs or short circuit the cables to
ground.
Remove spark plug cable from coil first.
Always remove the spark plug cable by grasping the top of the spark plug insulator, turning the boot 1/2 turn and pulling straight up in a steady motion.
INSTALLATION
Failure to route the cables properly could cause the radio to reproduce ignition noise, cross ignition of the spark plugs or short circuit the cables to
ground Install spark plug insulators over spark plugs Ensure the top of the spark plug insulator covers the upper end of the spark plug tube, then connect
the other end to coil pack