Sebring Sedan L4-2.4L VIN J (2004)
3. Using a lint free towel, wipe clean all open power steering hose ends, and power steering pump fittings.
4. Install a NEW O-ring on each end fitting of steering pressure hose. Lubricate all O-rings using fresh clean power steering fluid.
5. Install pressure hose into power steering gear port (Fig. 12). Thread tube nut into port and tighten to 31 Nm (275 In. lbs.) torque.
6. Install pressure hose into pump pressure fitting (Fig. 3) (Fig. 4). Thread tube nut into port and tighten to 31 Nm (275 inch lbs.) torque.
7. Install accessory drive splash shield.
8. Install left front wheel and tire assembly. Progressively tighten all wheel lug nuts using a crisscross pattern to 135 Nm (100 ft. lbs.) torque.
9. Lower vehicle.
10. Install remote battery ground cable on ground stud located on left shock tower.
11. Fill reservoir with fluid and bleed system using Power Steering Pump Initial Operation standard procedure.
12. Check for leaks.