Sebring Sedan L4-2.4L VIN J (2004)
2. Install lower control arm ball joint stud into steering knuckle. Install the steering knuckle to ball joint stud castle nut (Fig. 21). Do not tighten nut
at this time.
CAUTION: When installing tie rod on steering knuckle, the heat shield (Fig. 35) must be installed. If heat shield is not installed, tie rod seal boot can
fail due to excessive heat from brake rotor.
3. Install outer tie rod stud into steering knuckle. Start outer tie rod-to-steering knuckle attaching nut onto tie rod stud. While holding stud of tie rod
end stationary, tighten nut using a crowfoot and 11/32 socket. Tighten nut to 61 Nm (45 ft. lbs.) torque (Fig. 35).