Sebring Sedan L4-2.4L VIN J (2004)
Tires: Removal and Replacement
STANDARD PROCEDURE - TIRE LEAK REPAIRING
For proper repairing, a radial tire must be removed from the wheel. Repairs should only be made if the defect, or puncture, is in the tread area (Fig.
18). The tire should be replaced if the puncture is located in the sidewall.
Deflate tire completely before attempting to dismount the tire from the wheel. Use a lubricant such as a mild soap solution when dismounting or
mounting tire. Use tools free of burrs or sharp edges which could damage the tire or wheel rim.
Before mounting tire on wheel, make sure all rust is removed from the rim bead and repaint if necessary.
Install wheel on vehicle, and progressively tighten the 5 wheel nuts to a torque of 135 Nm (100 ft. lbs.).
CLEANING - TIRES
Before delivery of a vehicle, remove the protective coating on the tires with white sidewalls or raised white letters. To remove the protective coating,
apply warm water and let it soak for a few minutes. Afterwards, scrub the coating away with a soft bristle brush. Steam cleaning may also be used to
remove the coating.
CAUTION: DO NOT use gasoline, mineral oil, oilbased solvent or a wire brush for cleaning.
