Sebring Sedan L4-2.4L VIN X (2001)
Front Door Weatherstrip: Service and Repair
A - Pillar Seal
A - PILLAR SEAL
REMOVAL
1. Open front door.
2. Using a fork-type tool (C-4829), disengage push-in fasteners attaching A-pillar seal to A-pillar.
3. Remove A-pillar seal from vehicle.
INSTALLATION
1. Place A-pillar seal into position.
2. Install push-in fasteners attaching A-pillar seal to A-pillar.
3. Close front door.
Drip Rail Weatherstrip
DRIP RAIL WEATHERSTRIP
REMOVAL
1. Open front and rear doors.
Fig. 5
2. Remove two screws (Fig. 5).
3. Position splash shield out of way.
4. Starting at the bottom of the A-pillar, pull the drip rail weatherstrip from the windshield side molding.
5. Pull the drip rail weatherstrip from the roof rail pinch flange above door openings.