Sebring Sedan L4-2.4L VIN X (2001)
6. Install the anti-rattle spring on the outboard side of the caliper. Start the clip into the holes on the caliper, then stretch the clip legs past the
abutments on the caliper adapter.
CAUTION: When connecting the brake hose to the caliper, install new brake hose to caliper special washers.
7. Install the brake hose on the caliper. To do this, first place one NEW special fitting washer on each side of the hose fitting, then slide the banjo
bolt through the fitting. Next, thread the banjo bolt into the threaded port on the rear of the brake caliper. Tighten the banjo bolt to a torque of 35
Nm (26 ft. lbs.).
8. Install the wheel and tire assembly. Tighten the wheel mounting stud nuts in proper sequence until all nuts are torqued to half specification, then
repeat the tightening sequence to the full specified torque of 135 Nm (100 ft. lbs.).
9. Lower the vehicle.
10. Remove the brake pedal depressor (holding) tool.
11. Bleed the hydraulic brake circuit to the brake caliper.
12. Road test the vehicle and make several stops to wear off any foreign material on the brakes and to seat the brake shoe linings.
Rear
REMOVAL - REAR DISC BRAKE CALIPER
1. Depress the brake pedal past its first inch of travel and hold it in this position using a brake pedal depressor (holding) tool. This is done to isolate
the master cylinder from the brake hydraulic system disallowing the brake fluid to completely drain out of the brake fluid reservoir.
2. Raise vehicle.
3. Remove rear wheel and tire from vehicle.
4. Remove the banjo bolt connecting the brake hose to the brake caliper. There are two washers (one on each side of the brake hose fitting) that will
come off with the banjo bolt. Discard these washers.
Caliper Assembly Guide Pin Bolts
5. Remove the 2 guide pin bolts mounting the caliper to the adapter.
