Sebring Sedan L4-2.4L VIN X (2001)
1. Install new intake manifold and gasket. Gradually tighten fasteners to 12 Nm (105 in. lbs.) in sequence shown in (Fig. 98).
2. Install coolant outlet connector.
3. Install fuel rail.
4. Connect previously disconnected electrical connectors.
5. Install fastener holding fuel rail bracket to side of cylinder head.
6. Inspect quick connect fittings for damage, replace if necessary. Connect fuel supply hose to fuel rail assembly. Check connection by pulling on
connector to insure it locked into position.
7. Connect vacuum hoses to intake manifold.
8. Install engine oil dipstick and tube.
9. Install EGR tube.
10. Install throttle and speed control cables to bracket. Connect cables to the throttle lever.
11. Fill cooling system.
12. Connect negative battery cable.
13. With the DRB scan tool use ASD Fuel System Test to pressurize system to check for leaks.
CAUTION: When using the ASD Fuel System Test, the Auto Shutdown (ASD) relay will remain energized for 7 minutes or until the Ignition
switch is turned to the OFF position, or Stop All Test is selected.