Sebring Sedan V6-2.7L VIN R (2004)
Solar Sensor: Service and Repair
REMOVAL
WARNING: ON VEHICLES EQUIPPED WITH AIR-BAGS, DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY
STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT AND
ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE AIRBAG SYSTEM CAPACITOR
TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE
AIRBAG SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN AN ACCIDENTAL AIRBAG
DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
1. Open the hood and disconnect the negative battery cable remote terminal from the remote battery post.
2. Remove the instrument panel top cover.
3. Remove the two Sun Sensor mounting screws.
4. Lift the sensor out of the instrument panel and disconnect the wiring.
5. Remove the sensor from the vehicle.
INSTALLATION
1. Connect the wiring harness connector to the sensor and position in the vehicle.
2. Install the two sensor fasteners.
3. Install the instrument panel top cover.
4. Connect the negative battery cable remote terminal to the remote battery post.
CAUTION: The sun sensor must protrude approximately 1/4 inch above the instrument panel top cover. This will ensure proper operation.
If the sensor does not protrude 1/4 inch, perform the following procedure:
-
Confirm that the top cover is properly installed
-
Remove the top cover
-
Remove fasteners from sun sensor
-
Install one 1/4-20 nut per fastener under the sun sensor so that it is shimmed higher
-
Reinstall the sun sensor. Do not overtighten screw. If a longer screw is required, use 8-15x1 inch.
