Sebring Sedan V6-2.7L VIN R (2004)
Windshield Washer Pump: Service and Repair
WASHER RESERVOIR PUMP
REMOVAL
1. Disconnect and isolate the battery negative remote cable.
2. Partially remove the bumper fascia as needed to gain access to the reservoir pump. Refer to Frame & Bumpers, Bumpers, Front Fascia, Removal.
3. Place a drain bucket below the reservoir to catch any washer solvent that may leak out.
4. Firmly grasping pump by hand twist and pull away from reservoir and out of grommet. Care must be taken not to puncture reservoir.
5. Remover rubber grommet from reservoir and throw away.
INSTALLATION
1. A new grommet is required for installation.
2. Firmly grasping pump by hand twist and push into reservoir. Care must be taken not to tear grommet or puncture reservoir.
3. If fascia was partially removed, reinstall bumper fascia as needed. Refer to Frame & Bumpers, Bumpers, Front Fascia, Installation.
4. Refill reservoir with the washer solvent.
5. Connect the battery negative remote cable.
