Sebring Sedan V6-2.7L VIN T FFV (2003)
7.
Install the two screws that secure the blower motor resistor to the HVAC housing. Tighten the screws to 2 Nm (17 in.lbs.).
8.
Connect the wire harness connector to the blower motor resistor.
9.
Install the silencer panel to the right side of the instrument panel (Refer to 23 - BODY/INSTRUMENT PANEL/RIGHT IP SILENCER PANEL -
INSTALLATION).
10. Reconnect the negative battery cable.
11. Set the clock to the correct time.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
FAILURE CODE:
Disclaimer:
This bulletin is supplied as technical information only and is not an authorization for repair.