Sebring Sedan V6-2.7L VIN T FFV (2003)
6. If the interlock cable is being replaced, remove the lock pin (Fig. 290). This will allow the cable to "self adjust" to the correct position. Tighten the
locking clip by pushing it down (Fig. 291).
7. If the interlock cable is not being replaced, the lock pin will not exist. Pull outward on cable locking clip to allow cable to self adjust. Press clip
down to lock in place (Fig. 291).
8. Verify Brake/Transmission Shift Interlock system operation. Refer to operation chart in "Verification."
9. Install the gearshift bezel (Fig. 289).
10. Install the gearshift knob and tighten set screw (Fig. 288) to 2 Nm (20 in. lbs.).
11. Connect the battery negative cable.