Sebring Sedan V6-3.5L (2009)
11. Install air cleaner housing and inlet hose See: Tune-up and Engine Performance Checks/Air Cleaner Housing/Service and Repair/Air Cleaner
Body - Installation.
12. Connect negative battery cable See: Starting and Charging/Battery/Service and Repair/Procedures/Battery Reconnection.
13. Install the engine cover.
Intake Manifold Lower
LOWER INTAKE MANIFOLD
1. Clean all sealing surfaces.
2. Position new gaskets and intake manifold on cylinder head surfaces.
3. Position the ignition coil capacitor and install the intake manifold bolts. Gradually tighten in sequence shown until a torque of 28 Nm (250 in. lbs.)
is obtained.
4. Install fuel rail and injectors as an assembly.