Sebring Sedan V6-3.5L (2009)
12. Remove the two ignition switch mounting screws (1) and remove one upper screw from the ignition cylinder support bracket.
13. Disconnect the WCM antenna from the WCM receiver.
14. Use a thin screw driver and unclip ignition switch from mounting position. Push switch back to remove.
15. Remove the ignition switch/cylinder assembly through the lower steering column opening.
16. Remove WCM retaining screw (1) and flex the retaining tab to release the WCM from the ignition switch.
NOTE: After a SKREEM/WCM is replaced, the ignition/transponder keys need to be programmed to the new SKREEM/WCM. Follow the
directions on the diagnostic scan tool. The transponder key for the SKREES/SKIM and the RKE will both be programmed during
this operation. There is no need to program the fob of the key for RKE functionality once the transponder key is programmed to the
new SKREEM/WCM.
