Town & Country V6-3.3L VIN R (2003)
Sliding Door Weatherstrip: Service and Repair
SLIDING DOOR WEATHERSTRIP
REMOVAL
1. Open sliding door.
2. Remove door opening sill plate.
3. Loosen B-pillar trim covers.
4. Loosen quarter panel trim panels.
5. From splice at the bottom center of door opening, pull weatherstrip from pinch flange around door opening.
INSTALLATION
1. Place splice at the bottom center of door opening, pushing weatherstrip onto pinch flange around door opening.
2. Tighten quarter panel trim panels.
3. Tighten B-pillar trim covers.
4. Install door opening sill plate.
5. Close sliding and check alignment.
