Town & Country V6-3.8L (2009)
Collision Avoidance Sensor: Service and Repair
Blind Spot Sensor - Removal
REMOVAL
NOTE: The sensor brackets are bonded to and integral to the back side of the rear bumper fascia.
1. Disconnect and isolate the negative battery cable.
2. Remove the bumper fascia (2) from the rear of the vehicle. See: Body and Frame/Bumper/Rear Bumper/Rear Bumper Cover / Fascia/Service and
Repair/Rear Bumper Fascia - Removal.
3. From the back of the fascia, disconnect the wire harness connector (5) from the blind spot monitor sensor (6) connector receptacle.
4. Carefully pry the sensor bracket latch features away from the top and bottom latch tabs of the sensor far enough to disengage the sensor from the
bracket.