Town & Country V6-3.8L (2009)
Garage Door Opener Transmitter: Component Tests and General Diagnostics
HOMELINK(R) TRANSCEIVER
RADIO FREQUENCY DETECTOR 9001
If the HomeLink(R) transceiver is inoperative, retrain the transceiver with a known good transmitter, insuring the transmitter battery is OK,See:
Programming and Relearning for the proper procedure. Test the universal transmitter operation again. If the unit is still inoperative, test the universal
transmitter with Radio Frequency Detector special tool as described below:
1. Turn the Radio Frequency (RF) Detector ON (3). A "chirp" will sound and the green power Light Emitting Diode (LED) will light (2). If the green
LED does not light, replace the battery (4).
2. Hold the RF detector within one inch of the TRAINED universal transmitter and press any of the transmitters buttons.
3. The red signal detection LEDs (1) will light and the tool will beep if a radio signal is detected. Repeat this test for all three transmitter buttons. If
the tool does not detect a radio signal for any of the three buttons, replace the inoperative HomeLink(R) transceiver assembly, See: Body and
Frame/Interior Moulding / Trim/Sun Visor/Service and Repair/Visor - Removal.
