Town & Country V6-3.8L (2009)
Sliding Door Latch: Service and Repair
Hold Open Latch Cable - Removal
REMOVAL
NOTE: For power sliding door procedures refer to POWER SLIDING DOOR SYSTEM.
1. Disconnect and isolate the negative battery cable.
2. Remove the appropriate side door trim panel from the vehicle. See: Sliding Door Interior Trim Panel/Service and Repair/Door Trim Panel -
Removal
CAUTION: Make note of cable routing and foam insulator placement. This will prove helpful when reinstalling replacement cable. Be certain
replacement cable is routed and retained correctly.
3. Remove the hold open latch from the side door. See: Sliding Door Latch - Removal.
4. Disconnect the hold open latch cable from the hold open latch. Gently pry cable sleeve retainer out of the handle bracket and then unhook swedged
cable end from the latch link.
5. Disconnect the hold open latch cable from the latch assembly. Gently pry cable sleeve retainer out of the latch mounting bracket and then unhook
swedged cable end from the latch link.
6. Remove the door module assembly. See: Service and Repair/Carrier Plate - Removal.
7. Trace the hold open latch cable along its routing path and disconnect from its retaining clips.
8. Remove the hold open latch cable from the side door.