Town & Country V6-3.8L (2009)
2. Install the seat back cover (2) and the seat back cushion (3) onto the seat back frame (5) as an assembly.
3. Engage the seat back cover to the two metal tabs (4) located near the bottom of the seat back frame.
4. Engage the five J-hook retainers (1) that secure the top and sides of the seat back cover to the seat back frame.
5. Install the headrest sleeves See: Head Rest/Service and Repair/Headrest Sleeve - Installation.
6. Install the headrest See: Head Rest/Service and Repair/Headrest - Installation.
7. Install the armrest See: Interior Moulding / Trim/Arm Rest/Service and Repair/Armrest - Installation.
8. Install the seat back panel See: Seat Back/Service and Repair/Seat Back Panel - Installation.
9. Install the seat back onto the seat See: Seat Back/Service and Repair/Seat Back - Installation.
10. Install the seat into the vehicle See: Service and Repair/Removal and Replacement/Seats, First Row/Seat - Installation.
Second Row, Swivel
INSTALLATION
NOTE: Right seat shown in illustrations. Left seat similar.
1. Position the seat back cushion (6) onto the seat back frame (5). If equipped, make sure the heated seat wire harness lead is correctly routed to the
bottom of the seat.
2. Install the seat back cover (2) over the top of the seat back frame and cushion.
3. Engage the retaining strip (3) that secures the seat back cover to the seat back cushion. Slide the strip on the cover into the channel in the cushion.
4. Engage the two hook and loop retainers (1 and 4) that secure the seat back cover to the seat back cushion.
5. Engage the three J-hook retainers (1) that secure the seat back cover (2) to the seat back.
6. Engage the two hook and loop retainers (3) at the bottom of the seat back cover.
