Town & Country V6-3.8L (2009)
5. Attach wheel speed sensor routing bracket (3) to mounting flange (2) on strut assembly. Install and tighten screw (1) to 10 Nm (89 in. lbs.).
Install wheel speed sensor grommet (2) into flex hose bracket (1) on frame rail.
6. Clip wheel speed sensor connector and routing clip (3) to bracket (2) on frame rail.
7. Connect vehicle wiring harness (1) to wheel speed sensor connector.
8. Install brake shield on knuckle. Install and tighten three mounting screws to 8 Nm (71 in. lbs.).
9. Install brake rotor as well as all components necessary to access it. See: Disc Brake System/Brake Rotor/Disc/Service and Repair/Removal and
Replacement/Brake Rotor - Installation
10. Verify that wheel speed sensor cable is properly routed and not coming into contact with rotor or other moving parts.