Town & Country V6-3.8L (2009)
Wheel Bearing: Service and Repair
Front Hub and Bearing - Installation
INSTALLATION
CAUTION: Hub and bearing mounting surfaces on knuckle and stub shaft (2) must be smooth and completely free of foreign material or nicks
prior to installing hub and bearing assembly.
1. Make sure isolation washer (1) is located on halfshaft stub shaft (2). Washer is bi-directional, and can be installed in either direction.
2. Install hub and bearing (3) onto halfshaft stub shaft (2) and into knuckle until squarely seated on face of knuckle. Make sure wheel speed sensor is
positioned toward rear of vehicle.
3. Install four hub and bearing mounting bolts (2) from rear of knuckle (1). Progressively and equally tighten all four mounting bolts using a
crisscross pattern. Tighten mounting bolts to 65 Nm (45 ft. lbs.).