Town & Country V6-3.8L (2009)
Evaporator Temperature Sensor / Switch: Service and Repair
Front Evaporator Temperature Sensor - Removal
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the
proper precautions may result in accidental airbag deployment and possible serious or fatal injury.
1. Disconnect and isolate the negative battery cable.
2. If equipped, remove the silencer from below the passenger side of the instrument panel.
3. Disconnect the wire harness connector (2) from the evaporator temperature sensor (3) located on the side of the front HVAC housing (1).
4. Remove the evaporator temperature sensor from the front HVAC housing.