Town & Country V6-3.8L VIN L (2006)
![background image](/chrysler/town_&_country/v6-3.8l_vin_l/Page-2156001.png)
Driver/Vehicle Information Display: Programming and Relearning
Programming Transmiter Codes
1. Turn off the engine.
2. Erase the codes by pressing the two outside buttons. Release the buttons when the display confirms the operation (about 20 seconds).
3. Choose one of the three buttons to train. Place the hand-held transmitter within one inch of the universal transmitter and push the buttons on both
transmitters.
4. Release both buttons. Your universal transmitter is now "trained". To train the other buttons, repeat Step 3 and Step 4. Be sure to keep your
handheld transmitter in case you need to retrain the universal transmitter.
Erasing Transmitter Codes
To erase the universal transmitter codes, simply hold down the two outside buttons until the display confirms the operation.
NOTE: Individual channels cannot be erased. Erasing the transmitter codes will erase ALL programmed codes.
Diagnosis By Symptom
Test 1 - Test 4
SYMPTOM
REPAIRING CMTC DISPLAYS DOUBLE DASH ( - - ) IN TEMP DISPLAY
POSSIBLE CAUSES
-
No response - PCI bus - powertrain control module
-
CMTC bus message failure
-
Compass mini-trip computer
-
Ambient temperature sensor
-
PCM ambient air temperature sensor DTC present