Town & Country V6-3.8L VIN L (2006)
Speaker: Service and Repair
D-Pillar Speaker
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove rear header trim (right side speaker).
3. Remove jack cover (left side speaker).
4. Remove liftgate scuff plate.
5. Remove upper seat belt bolt.
6. Partially remove quarter trim panel to access the D-pillar speaker.
D-Pillar Speaker
7. Slide the speaker from the retainer.
8. Disconnect the wire harness connector from the speaker.
INSTALLATION
1. Connect the wire harness connector to the speaker.
2. Slide the speaker into the retainer.
3. Install quarter panel trim.
4. Install upper seat belt bolt (right side).
5. Install liftgate scuff plate.
6. Install rear header trim (right side).
7. Install jack cover (left side).
8. Connect battery negative cable.