Town & Country V6-3.8L VIN L (2006)
Parking Assist Distance Sensor: Service and Repair
REMOVAL
1. Open hood.
2. Disconnect and isolate the battery negative cable.
3. Remove rear fascia.
Sensor Retaining Clip
4. Remove the sensor retaining clip from the back side of the fascia.
Sensor Remove/Install
5. Push the Park Assist Sensor out of the fascia.
INSTALLATION
1. Position the Park Assist Sensor over the retaining housing and firmly snap into housing in rear fascia.
2. Install the rear fascia.
3. Connect the battery negative cable.
4. Close hood.
5. Verify vehicle and system operation.