Town & Country V6-3.8L VIN L (2006)
Front Bumper Reinforcement: Service and Repair
FRONT BUMPER REINFORCEMENT
REMOVAL
1. Remove front bumper fascia. Refer to Front Bumper Cover/Fascia.
2. Disconnect the solid state relay (SSR) for the cooling module wiring connector. If bumper reinforcement is being replaced, remove the solid state
relay.
3. Support front bumper reinforcement on a suitable lifting device.
Fig. 3
4. Remove the four nuts attaching front bumper reinforcement to frame rail (Fig. 3).
5. Remove front bumper reinforcement from vehicle.
INSTALLATION
NOTE: Check position of the arrows molded into the foam for correct orientation.
1. Support front bumper reinforcement using a suitable lifting device and lift into position.
2. Install the four nuts attaching reinforcement to frame rails. Tighten nuts to 54 N.m (40 ft.lbs.) torque.
3. Connect the solid state relay (SSR) wiring connector. If bumper reinforcement was replaced, install the solid state relay onto the bumper
reinforcement.
4. Install front fascia.