Town & Country V6-3.8L VIN L (2006)
Trunk / Liftgate Handle: Service and Repair
EXTERIOR HANDLE
REMOVAL
1. Remove liftgate trim panel.
2. Disconnect the exterior handle electrical connectors.
3. Remove the two outer screws and the two inner screws.
4. Remove the exterior handle/license plate light assembly.
INSTALLATION
1. Route the exterior handle electrical connector through the door and position handle.
2. Install the two out screws and tighten to 3 N.m (22 in.lbs.).
3. Install the two inner bolts and tighten to 5 N.m (40 in.lbs.).
4. Connect the electrical connector.
5. Install the trim panel.