Town & Country V6-3.8L VIN L (2006)
Power Latch Orientation
2. Connect the liftgate lock cylinder link rod on the cinch latch assembly. Rotate the plastic retaining clip 90 ° to lock retaining clip onto the link rod.
3. Connect the link rod on the lock cylinder.
4. Install three new power latch retaining bolts. Torque to 10 Nm (90 in. lbs.).
5. Connect the power latch electrical connector and secure push pin retainers.
6. Connect the battery negative cable.
7. Using an appropriate scan tool, check and erase any power liftgate control module diagnostic trouble codes related to the power latch.
8. Verify power liftgate system and power cinch / release latch operation. Cycle the power liftgate through one complete open and close cycle, this
will allow the power liftgate control module to relearn its cycle with the new components.
9. Verify power liftgate manual operation. Using liftgate key rotate the lock cylinder to verify door operation. Pull door open using exterior liftgate
handle / switch.
10. Install the liftgate trim panel.
Latch Actuator
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Open the liftgate and remove the lower liftgate trim panel.