Town & Country V6-3.8L VIN L (2006)
Trunk / Liftgate Latch: Removal and Replacement
LATCH
REMOVAL
1. Remove liftgate trim panel.
2. Disengage outside key cylinder link from clip on latch.
Fig. 2
3. Disconnect wire connector from liftgate latch (Fig. 2).
4. Remove screws attaching latch to liftgate.
5. Remove latch from vehicle.
INSTALLATION
1. Engage key cylinder link and place latch in position on vehicle.
2. Install screws attaching latch to liftgate. Tighten to 11 N.m (95 in.lbs.) torque.
3. Connect wire connector to liftgate latch.
4. Verify liftgate fit and operation. Adjust as necessary.
5. Install liftgate trim panel.