Town & Country V6-3.8L VIN L (2006)
Trunk / Liftgate Motor: Service and Repair
Engage Actuator
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the left rear D-pillar trim from the vehicle.
3. Manually engage the actuator link rod, this must be done to access one of the engage actuator retaining screws.
Liftgate Gear Motor Assembly
4. Remove the two engage actuator retaining screws.
5. Disconnect the engage actuator electrical connector and remove the engage actuator from the vehicle.
INSTALLATION
1. Position the engage actuator in the vehicle and connect the engage actuator electrical connector.
2. Install the two engage actuator retaining screws.
3. Manually disengage the actuator.
4. Install the left rear D-pillar trim on the vehicle.
5. Connect the battery negative cable.
6. Using an appropriate scan tool, check and erase any power liftgate control module diagnostic trouble codes.
7. Verify power liftgate system and engage actuator operation. Cycle the power liftgate through one complete open and close cycle.