Town & Country V6-3.8L VIN L (2006)
Body Emblem: Service and Repair
Exterior Name Plates - Adhesive Attached
EXTERIOR NAME PLATES -ADHESIVE ATTACHED
REMOVAL
1. Mark reference points before removing.
2. Using a heat gun gently apply heat in a circular motion to loosen the adhesive bond.
3. With your fingernail lift up and peel away badgeing/tape from panel, using a heat gun as you go.
4. Clean off all traces of adhesive from the panel(s) with a general purpose adhesive remover.
INSTALLATION
1. Clean panel surface with isopropyl alcohol.
2. Remove paper carrier and align badgeing/tape to reference points or adjacent panel.
3. Install and press securely, using a plastic spreader to eliminate all air bubbles.
4. Remove top protective carrier.
5. Clean away any reference points.