Town & Country V6-3.8L VIN L (2006)
Fig. 27 Leading Brake Shoe Hold Down Spring And Pin
12. Remove the leading brake shoe assembly to brake support plate hold down spring and pin (Fig. 27) from the brake shoe. Remove the leading brake
shoe from the brake support plate.
Fig. 28 Park Brake Actuator Plate
13. Remove the park brake actuator (Fig. 28) from the leading brake shoe and transfer to the replacement brake shoe.
INSPECTION - REAR DRUM BRAKE SHOE LINING
1. Remove the tire and wheel assembly from the vehicle
2. Remove the rear brake adjusting hole plug found in the brake support.
3. Insert a thin screwdriver into brake adjusting hole to hold the adjusting lever away from the notches on the adjusting screw star wheel.
4. Insert Tool C-3784 into brake adjusting hole and engage notches of brake adjusting screw star wheel. Release brake by prying down with adjusting
tool.
5. Remove the rear brake drum from the rear hub and bearing assembly.
6. Inspect brake lining for wear, shoe alignment, and or contamination from grease or brake fluid.
INSTALLATION - REAR DRUM BRAKE SHOES