Town & Country V6-3.8L VIN L (2006)
1. With engine not running, pump brake pedal until a firm pedal is achieved (4 or 5 strokes).
2. Disconnect negative battery terminal.
3. Disconnect positive battery terminal.
4. Remove battery shield.
5. Remove nut and clamp securing battery to tray, remove battery.
6. Thoroughly clean all surfaces of the brake fluid reservoir and master cylinder. Use only solvent such as Mopar Brake Parts Cleaner or equivalent.
Fig. 46 RHD MASTER CYLINDER AND POWER BRAKE BOOSTER
7. Remove wiring harness connector from brake fluid level switch in master cylinder brake fluid reservoir (Fig. 46).
Fig. 50 RHD MASTER CYLINDER MOUNTING
8. Disconnect primary and secondary brake tubes from master cylinder housing (Fig. 50). Install sealing plugs in the now open brake tube outlet
ports.
CAUTION: Before removing the master cylinder from the power brake vacuum booster, the master cylinder and vacuum booster must be
thoroughly cleaned. This must be done to prevent dirt particles from failing into the power brake vacuum booster.
9. Clean area where master cylinder assembly attaches to power brake booster. Use only a solvent such as Mopar Brake Parts Cleaner or equivalent.
10. Remove two nuts attaching master cylinder to power brake booster (Fig. 50).
11. Slide master cylinder straight out of power brake booster.
CAUTION: A seal on the rear of the master cylinder is used to create the seal for holding vacuum in the power brake vacuum booster. The