Town & Country V6-3.8L VIN L (2006)
Fig. 36 Solenoid Valve Seal
Fig. 37 Internal Pump Connector O-Ring
2. If the seals on the components are not new, they must be replaced. Each of the solenoid valve stem seals must be replaced (Fig. 36); do not reuse
solenoid valve stem seals. The pump/motor connector O-ring should also be replaced if not new (Fig. 37).
3. Align components and install the ABM on the HCU (Fig. 35).
4. If not equipped with traction control, install the three screws attaching the ABM to the HCU (Fig. 33). Tighten the mounting screws to 2 Nm (17
inch lbs.) torque.
5. If equipped with traction control, install the four screws attaching the ABM to the HCU (Fig. 34). Tighten the mounting screws to 2 Nm (17 inch
lbs.) torque.
6. Install the ICU in the vehicle.