Town & Country V6-3.8L VIN L (2006)
Fig. 122 Cable Removal Using Wrench
10. Place a 13 mm 12-point box wrench over the cable retainer at the intermediate bracket as shown to collapse the retainer fingers (Fig. 122).
Fig. 123 Cable Intermediate Bracket
11. Pull the cable out of the intermediate bracket and remove it from the vehicle (Fig. 123).
INSTALLATION - RIGHT REAR
1. Install the rear parking brake cable in the brake support plate. Insert cable housing retainer into brake support plate making certain that cable
housing retainer fingers lock the housing and retainer firmly into place.
2. Attach the parking brake cable onto the parking brake actuator lever.
3. Install the brake shoes on the rear brake support plate.
4. Insert cable housing retainer into body outrigger bracket making certain that cable housing retainer fingers lock the housing firmly into place.
5. Connect the right rear parking brake cable to the connector on the intermediate parking brake cable (Fig. 111).
6. Install the brake drum, then the wheel and tire assembly.
7. Remove the locking pliers from the front park brake cable. This will automatically adjust the park brake cables.
8. Lower the vehicle.
9. Apply and release park brake pedal 1 time. This will seat the park brake cables.