Town & Country V6-3.8L VIN L (2006)
Fig. 140 Hub/Bearing Removal/Installation (AWD Shown)
19. Remove the hub/bearing (Fig. 140).
Fig. 141 Hub/Bearing Removal From Caliper Adapter
CAUTION: Corrosion may occur between the hub/ bearing and the axle flange. If this occurs, the hub/ bearing will be difficult to remove from
the axle and disc brake caliper adapter. If the hub/bearing will not come out by pulling on it by hand, don't not pound on it with a hammer.
Pounding on the hub/ bearing will damage it. To remove a hub/bearing that is corroded in place, lightly tap the disc brake caliper adapter using a
soft-face hammer. This will remove both the caliper adapter and hub/bearing together from the axle. With a helper supporting the caliper adapter
in his hands, position Remover, Special Tool 8214-1, on the cast housing of hub/ bearing (Fig. 141). Do not position the special tool on the inner
race of hub/bearing. Lightly strike the Remover with a hammer to remove the hub/bearing from the caliper adapter.
20. Remove the adapter from the rear axle.