Town & Country V6-3.8L VIN L (2006)
6. While pulling the accelerator pedal upward and pushing the brake pedal downward for clearance, remove the heater core from the air distribution
housing.
INSTALLATION
1. While pushing the brake pedal downward and pulling the accelerator pedal upward for clearance, install the heater core into the HVAC air
distribution housing.
2. Install the two screws that secure the heater core to the air distribution housing. Tighten the screws to 2 N.m (17 in. lbs.).
3. Install the heater core tubes.
4. Connect the power brake booster input rod (push rod) to the pin on the brake pedal arm.
5. Install the brake lamp switch into its mounting bracket.
6. Install the silencer boot around the base of the lower steering shaft on the dash panel.
7. Reconnect the negative battery cable.
8. If the heater core is being replaced, flush the cooling system.
9. Refill the engine cooling system.