chrysler Workshop Repair Guides

Chrysler Workshop Service and Repair Manuals

Air Intake Pipe|Page 5429 > < Air Intake Pipe|Page 5427
Page 1
background image

Auxiliary Cabin Heater: Service and Repair
Fuel Line

Cleaning

1. Remove the cabin heater fuel line.
2. With the cabin heater fuel line removed from the vehicle, place a shop cloth on the fuel tank end of the fuel line to catch any residue, then apply a

small amount of air pressure to the other end of the fuel line.

3. Check to see if air pressure is coming from the tank end of the line. If pressure is flowing unrestricted the line is clean.
4. If the fuel line shows any signs of being restricted after air pressure is applied, the fuel line should be replaced.
5. Install the cabin heater fuel line.
6. Verify function of the cabin heater.

Removal and Installation

REMOVAL

CAUTION:  Make sure that the hoist is properly positioned under the vehicle to prevent damage to the flexible section of the cabin heater exhaust tube.

1. Raise and support the vehicle.

NOTE:  Utilize an approved fuel storage container to catch any residual fuel that may drain from the heater fuel hose or the dosing pump.

Dosing Pump Fuel Line SWB Shown, LWB Similar

2. Remove the two clamps that secure the heater fuel hose to the dosing pump and the heater fuel line.
3. Disconnect the heater fuel hose from the dosing pump and the heater fuel line.
4. Remove the clamp that secures the heater fuel line to the fuel tank.
5. Disconnect the heater fuel line from the fuel tank.
6. Disconnect the fuel line from the body retaining clips and remove the fuel line from vehicle.

INSTALLATION

WARNING:  DO NOT OPERATE THE DIESEL SUPPLEMENTAL CABIN HEATER IN AN ENCLOSED AREA SUCH AS A GARAGE
THAT DOES NOT HAVE EXHAUST VENTILATION FACILITIES. ALWAYS VENT THE CABIN HEATER EXHAUST WHEN
OPERATING THE CABIN HEATER. ALLOW THE DIESEL SUPPLEMENTAL CABIN HEATER TO COOL BEFORE PERFORMING
ANY SERVICE PROCEDURES TO THE CABIN HEATER. VERIFY THAT ALL DIESEL SUPPLEMENTAL CABIN HEATER FUEL
LINES ARE SECURELY FASTENED TO THEIR RESPECTIVE COMPONENTS BEFORE PERFORMING ANY SERVICE
PROCEDURES TO THE CABIN HEATER. FAILURE TO FOLLOW THESE INSTRUCTIONS MAY RESULT IN PERSONAL INJURY
OR DEATH
.

1. Position the cabin heater fuel line to the vehicle and connect the body retaining clips.

Air Intake Pipe|Page 5429 > < Air Intake Pipe|Page 5427