Town & Country V6-3.8L VIN L (2006)
Blower Motor: Description and Operation
Rear
Blower Motor Rear Description
The rear blower motor is a 12-volt, direct current (DC) motor mounted within a plastic housing with an integral wire connector and squirrel cage-type
blower wheel that is secured to the blower motor shaft. Three integral mounting tabs allow the rear blower motor to be secured to the outboard side of
the rear HVAC housing.
The rear blower motor can be accessed for service by removing the rear HVAC housing.
The rear blower motor is used to control the velocity of air moving through the rear HVAC housing by spinning the blower wheel within the rear HVAC
housing at the selected speed.
For diagnosis and testing of the rear blower motor, refer to Heating and Air Conditioning.
The rear blower motor will only operate when the ignition switch is in the On position and the front A/C-heater control is set to either front control of
rear heating-A/C system or to the rear control of the rear heating-A/C system. The rear blower motor receives a battery feed through the rear blower
motor relay located in the power distribution center (PDC), whenever the ignition switch is in the On position.
The rear blower motor and blower wheel are factory balanced and cannot be adjusted or repaired. If faulty or damaged, the blower motor and blower
wheel must be replaced as an assembly.