Town & Country V6-3.8L VIN L (2006)
Compass: Service and Repair
Overhead Console
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the overhead console retaining screw, located in the front of console.
3. Grasp the sides of the overhead console and pull straight down evenly to disengage the two snap clips at the rear of the unit.
4. Lower the overhead console far enough to access the wire harness connectors.
5. Disconnect the EVIC, CMTC or CT electronic module and the reading/courtesy lamps electrical connector.
6. Remove the overhead console from the vehicle.
INSTALLATION
1. Position the overhead console in the vehicle.
2. Connect the EVIC, CMTC or CT electronic module and the reading/courtesy lamps electrical connector.
3. Using your fingertips, grasp the sides of the overhead console and push straight up evenly to engage the two snap clips at the rear of the unit.
CAUTION: DO NOT PRESS ON THE SUNGLASS STORAGE BIN DOOR. DAMAGE TO THE DOOR MAY RESULT.
4. Install the overhead console retaining screw, located in the front of console. Torque the screw to 1.2 N.m (10 in. lbs.).
5. Connect the remote negative battery cable.