Town & Country V6-3.8L VIN L (2006)
Tire Pressure Sensor: Service and Repair
TIRE PRESSURE SENSOR
REMOVAL
1) Remove tire and wheel assembly from vehicle.
CAUTION: The cap used on this valve stem contains an O-ring seal to prevent contamination and moisture from entering the valve stem. Retain this
valve stem cap for reuse. Do not substitute a regular valve stem cap in its place.
CAUTION: The valve stem used on this vehicle is made of aluminum and the core is nickel plated brass. The original valve stem core must be
reinstalled and not substituted with a valve stem core made of a different material. This is required to prevent corrosion in the valve stem caused by
the different metals.
Fig. 19 Start Mount/Dismount Tool Within 10Degrees Of Valve Stem
Fig. 20 Sensor Mounting To Wheel
2) Dismount tire from wheel following tire changer manufacturers instructions while paying special attention to the following to avoid damaging the
pressure sensor: