Town & Country V6-3.8L VIN L (2006)
Engine Control Module Upper Mounting Bolts
4. Remove ECM upper mounting bolts.
5. Lift ECM from radiator support.
6. Disconnect ECM electrical connectors.
7. Separate ECM from mounting bracket.
INSTALLATION
1. Install ECM on mounting bracket.
2. Connect ECM electrical connectors.
3. Place ECM and bracket assembly in position on radiator support.
4. Install upper and lower mounting bolts.
5. Install left headlamp module.
6. Connect negative battery cable.
7. Program ECM as necessary.
Powertrain Control Module
REMOVAL
The PCM engine control strategy prevents reduced idle speeds until after the engine operates for 320 km (200 miles). If the PCM is replaced after 320
km (200 miles) of usage, update the mileage and vehicle identification number (VIN) in the new PCM. Use the DRBIII(R) scan tool to change the
millage and VIN in the PCM. If this step is not done a Diagnostic Trouble Code (DTC) may be set.