Town & Country V6-3.8L VIN L (2006)
Whenever a module is reprogrammed, the software in the DRBIII(R); must be programmed with the latest revision level available.
NOTE:
If this flash process is interrupted/aborted, the flash process should be restarted and then follow the directions on the DRBIII(R).
1.
Before beginning the flash procedure, remove any old flash files from the DRBIII(R) memory. To clear the memory from the MAIN MENU:
a.
Simultaneously press the "MORE" and "YES" keys.
b.
A screen will appear requesting a "COLD BOOT".
c.
Follow the on screen instructions by selecting the "F4" key.
d.
When the DRBIII(R) reboots to the MAIN MENU, proceed to Step # 2
2.
With the ignition switch in the "RUN" position, determine the original part number of the PCM currently in the vehicle. Using the DRBIII(R)
select:
a.
"DRBIII(R) Standalone".
b.
"1998 - 2007 Diagnostics".
c.
"All (Except Below)".
d.
"Engine".
e.
"Module Display".
f.
Record the "PCM part # " on the repair order for later reference.
3.
Connect the DRBIII(R) to TechCONNECT. Open TechTOOLS and verify that the "DRBIII(R) Status: Connected" message is in the upper right
corner of the TechTOOLS screen.
4.
Enter the "PCM part # " recorded in Step # 2 in the "Parts Criteria" area and select "Show Updates". TechTOOLS will populate the appropriate
flash file.
5.
Select the flash file.
6.
Select the "DRBIII" radio button which is next to the "Download/Update" button.
7.
Select the "Download/Update" button.
8.
Monitor the "Flash Download/Update Progress" window on the TechCONNECT and follow the instructions on TechCONNECT. When the flash
process is complete, proceed to Step # 9.
9.
Disconnect the DRBIII(R) from TechCONNECT.
10.
Open the hood and install a battery charger. Using a voltmeter, verify that the charging rate provides 13.2 - 13.5 volts. Set the battery charger to
continuous charge. Do not allow the charger to time out during the flash process. Remove the charger from the battery when the flash process is
complete.
NOTE:
Do not allow the charging voltage to climb above 13.5 volts during the flash process.
11.
Connect the DRBIII(R) to the vehicle.
12.
Download the flash file from the DRBIII(R) to the vehicle. Using the DRBIII(R) select:
a.
"Vehicle Flash".
b.
Follow the directions on the DRBIII(R) screen. When the flash process is complete, proceed to the next step.
NOTE:
Due to the PCM programming procedure, a DTC may be set in other modules within the vehicle, if so equipped. Some DTC's may cause the MIL to
illuminate. Check all modules using "Module Scan", record the DTC's, and erase these DTC's prior to returning the vehicle to the customer. Erase
any DTC's in the PCM only after all other modules have had their DTC's erased.